Table of Contents
Advertisement
Operation with Options & Accessories
The following descriptions detail how to operate and gain maximum benefit from the options
and accessories that may be fitted to your Priorclave.
Setting Lock Keyswitch Option
Fitted on Priorclaves without program memory to give an optional level of security this
keyswitch has two settings only, which are equivalent to positions 1 & 3 described previously.
The key can only be removed in position 1.
Printer
The printer if fitted is mounted on the right hand side of the control panel. This provides a
useful record of the cycle as well as an indication if any faults have occurred. The information
printed is as follows:
USER NAME
DEPARTMENT
AUTOCLAVE SERIAL NUMBER
DATE
CYCLE NUMBER
PROGRAM NUMBER
TEMPERATURE AND TIME AT CYCLE START
TEMPERATURE AND TIME AT END OF FREESTEAMING
TEMPERATURE AND TIME AT START OF PROCESS TIME
The temperature and time are then recorded at pre-set time intervals, until the end of
the process time.
TEMPERATURE AND TIME AT END OF PROCESS TIME
TEMPERATURE AND TIME AT CYCLE COMPLETE.
CYCLE PASS/FAIL/ABORT
(Fail means that a fault signal has occurred during the cycle or that the cycle was
aborted. See - Warning Indicators)
The above information will be printed in the order listed, allowing the information to
be read as it is printed.
Power On Self Test
The self test procedure is initiated by applying power to the printer while the paper feed
button is depressed. When the paper feed button is released a test print will be produced.
Replacing Paper Roll
34
(if provided at time of ordering)
(if provided at time of ordering)
(if multi-program memory option fitted)
(time is set to G.M.T)
Advertisement
Table of Contents
