Table of Contents
Advertisement
Fig. 5-58 Exploded drawing of seat support
1. Remove the seat cushion.
2. Remove the cover plates (1).
3. Undo the two Allen screws (6) at the rear on the
crossmember and remove them.
4. Undo the two Allen screws (9) at the front on the seat
support plate and remove them.
5. Loosen the four Allen screws (7) and (8) which are
located at the front and back to the sides of the seat
support plate to release tension so that the plate can
be moved more easily. Do not, however, remove these
screws completely.
1529686-AA
6. Pull or push the seat support plate (2) the required
width. A scale (3) has been fitted to the bottom part
of the seat support. Use this scale to read off the seat
width in centimeters.
7. Repeat these operations on the other side of the seat.
8. Now tighten all the screws again.
5.15.2 Adjusting the seat depth
Also refer to the previous chapter entitled 5.15.1
Adjusting seat width, page 68.
The seat depth can be adjusted in stages between
380 and 530 mm.
Tools:
•
4 mm Allen key
•
8 mm jaw spanner
•
oblique pliers
•
cable binder
Particular holes in the seat support must be used to
the screws depending on the required seat depth. It
may also be necessary to replace the seat support
plate.
1. Please use the following figures and the table to
determine which holes need to be used for the required
seat depth, and therefore whether the seat support
plate needs to be replaced or not.
Setup
69
Advertisement
Table of Contents
