Adjusting Standard Armrests (Until April 2017); Changing The Arm Support Position; Setting Height Of Armrests; Adjusting Width Of Armrests - Invacare Storm4 Series User Manual

Invacare® Storm®⁴ Series
5.3 Adjusting Standard Armrests (Until April
2017)

5.3.1 Changing the arm support position

Tools:
• 1 x Allen key 3 mm
The arm support has 12 possible positions.
1. To change the position of the arm support, loosen the
screw (1) and remove it.
2. The position of the arm support is adjusted by selecting
a combination of screw holes in the arm support and
the drill holes in the fixing plate.
3. Reposition the screws and tighten.

5.3.2 Setting height of armrests

• 3 mm Allen key
36
1. Loosen screw A.
2. Adjust armrest to desired height.
3. Re-tighten screw.

5.3.3 Adjusting width of armrests

WARNING!
Serious risk of injury if one of the armrests
falls out of its bracket because they have
been adjusted to a width which exceeds the
permissible value
– The width adjustment is fitted with red
markings A and the word "STOP". The
armrests must never be pulled out further
than the point at which the word "STOP" is
completely legible.
– Always tighten the fixing screws properly once
adjustments have been completed.
1529686-AA