Invacare® Dragon Vertic
5.7 Adjusting armrests and remote
5.7.1 Adjusting height of armrests
•
5 mm Allen key
1. Loosen the eight Allen screws (1) (only the four on the
right side are shown in the picture).
2. Adjust height of armrests.
3. Re-tighten screws.
5.7.2 Adjusting angle of swing-up armrest
•
5 mm Allen key
•
13 mm socket wrench
Risk of damage to the wheelchair if height of
armrests is unevenly adjusted
– The armrests should only ever be adjusted
parallel to each other, never higher on one side
and lower on the other.
36
1. Loosen counternut (1).
2. Adjust screw (2) until desired angle of armrest is
achieved.
3. Re-tighten counternut (1).
5.7.3 Adjusting resistance of swing-up armrest
The swing-up armrest is prevented from lowering under its
own weight by the pre-set resistance.
•
5 mm Allen key
1. Adjust screw (1) until desired resistance of armrest is
achieved.
1451170-L