Table of Contents
Advertisement
This equipment is made of new style,high intensity plastic.It fully shows the modem times light charac
tic with
teristic with beauty struture. And it is made accord to CE standard. Fully agree with the internation
standard of DMX
512 agreement.
When receive the product,please be careful to take and put,check if the product has damage or not be-
cause of transportation, and check the following parts:
1.Signal cable-1PC
3.User Manval-1PC
5.Service card-1PC
１.１Package
Unpacking the fixture
1.Open the flight case cover.
2.With one person on each side, lift the fixture out of the flight case.
Packing the fixture
1.Disconnect the fixture from power and allow it to cool.
2. djust the rotating support ,place it in the box.
A
Every person involvd with installation and maintenance of this device to:
-Be qualilfied
-Follow the instructions of this manual.
This device has been shipped with our premises in absolutely perfect condition.In order to maintain this co-
ndition and toensure a safe operation,it is absolutely necessary for the user to follow the safety instructions
and warning notes written in this manual.
Important:
The manufacturer will not accept liability for any resulting damages caused by the nonobservance of this
manual or any unauthorized modification to the device.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Never let the power-cord come into contact with other cables! Handle the power cord and all connections
with particular caution!
Make sure that the available voltage is not higher than stated on the rearpanel.
Always plug in the power plug least. Make suer that the power-switch is set to off-position before you con
ections with themains with particular caution!
Make sure that the power-cord is never crimped or damaged by sharp edges.Check the decice and the p-
ower-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Only handle the power-cord by the plug,Never pull out the plug by tugging the powercord.
This device falls under protection class I.Therefore it is essential to connect the yellow/green conductor
to earth.
The electric connection,repairs and servicing must be carried out by a qualified employee.
Do not connect this device to a dimmer pack.
Do not switch the fixture on and off in short intervals as this would reduce the lamp's life.
Do not touch the device's housing bare hands during its operation(housing becomes hot)!
For replacement use lamps and fuses of same type and rating only.
Eye damage!
Avoid looking directly into the light source(meant especially for epileptics)!
1.Open-Package guidelines
2. Safty cable-1PC
4.
2.Safety instructions
- 1 -
Omega bracket-1PCS
teris-
Advertisement
Table of Contents
