NEC MultiSync LT280 User Manual page 16

1. Preparing User Supportware 3
2
Click [Install Ulead Photo Explorer 8.0].
The "Welcome to Ulead Photo Explorer 8.0 SE Basic Setup" screen will be displayed.
3
Click [Next].
The "License Agreement" screen will be displayed.
Carefully read the contents of the "End User License Agreement".
4
If you agree to the End User License Agreement, click [Yes].
The "User Information" screen will be displayed.
5
Input [Name:] and [Company:], and click [Next].
The "Choose Destination Location" screen will be displayed.
• This software does not require you to input the "Serial Number".
• After that, follow the instructions on the screen to continue with the installation.
• When installation is complete, the menu screen of the User Supportware 3 CD-ROM is displayed
again.
G Installing Viewer PPT Converter 3.0
1
Click [Installing Viewer PPT Converter 3.0] on the menu screen.
Preparation for the installation will begin.
When preparation is complete, the "Welcome to the InstallShield Wizard for Viewer PPT Converter
3.0" screen is displayed.
• After that, follow the instructions on the screen to continue the installation.
• When installation is complete, the menu screen of the User Supportware 3 CD-ROM is displayed
again.
Note
• When Viewer PPT Converter 3.0 has been installed, once start Viewer PPT Converter
3.0 once with the privilege used for installation. Then exit from Viewer PPT Converter 3.0
without doing anything.
• Starting
Click Window's [Start] → [All Programs] → [NEC Projector User Supportware] →
[Viewer PPT Converter 3.0] → [Viewer PPT Converter 3.0], in that order.
16