Table of Contents
Advertisement
3.19.2 Rigid Media Fence Alignment Adjustments
Adjust the Fence as described in the following steps.
The Fence must be parallel to the Carriage Beam. Adjust the fence so it is parallel to the beam as described in the following steps.
1.
Place some rolled media onto the vacuum belt.
2.
Using the blue Carriage Height Gauge, make marks on the media to indicate where the beam is located.
3.
Do this on the left and right sides of the media.
Figure 3-53: Mark Left Side of Media
4.Once the marks are made there is a reference to the location of the beam.
5.
Adjustments to the fence can now be made.
Document ID: OMM-00131 Rev. E
Figure 3-55: Mark on Media
Figure 3-54: Mark Right Side of Media
54
- Quick Links:
- Operator Training Phase
Hide quick links:
Advertisement
Table of Contents
