EFI Pro 16h Installation Manual page 17

1. Thread the shafts into the installation location only far
enough to ensure that the wheels will not touch the floor
when the printer is lowered.
2. Check the installation before lowering the printer by mea-
suring the distance from the bottom of the printer to the
bottom of the rubber pads on the bottom of the feet to
ensure it is more than the wheel hight. (Approximately 4
Inches)
3. Ensure that all four feet are installed with the same
height measurement.
4. When all four feet are installed at the proper height, the
printer can be moved to its final location and lowered
onto the floor. (Ensure that only the feet make contact
with floor - the wheels must NOT touch the floor)
5. The printer can now be properly leveled.
Document ID: OMM-00131 Rev. E
4 Inches
Ensure Foot Extends Below Wheel
Figure 3-6: Printer Foot Measurement
Figure 3-7: Printer Foot Installed
17