Table of Contents
Advertisement
2.2.5 Fire or Explosion Risks and Precautions
Open flame, heat energy, or sparks around the printer can trigger a fire or an explosion when excessive fumes are present. Follow
the precautions listed below:
• Do not smoke near the printer or ink storage area.
• Do not allow open flame near the printer or ink storage area.
• Do not use heaters or halogen lights within five meters of the printer or ink storage area.
• Do not use spark producing equipment, including devices capable of static electrical discharge, within five meters of the printer or
ink storage area.
• Ensure proper use of fire extinguishers.
2.2.6 Risk of Eye and Skin Irritation
Follow these precautions:
• When ink or solvent comes in contact with your skin, thoroughly wash at once with cold water and designated soap(s).
• When ink or solvent comes in contact your eyes, thoroughly wash at once with cold water.
• Do not drink or swallow solvent, ink, or waste ink.
• Only authorized operators are allowed to handle inks and solvents.
• Keep inks, solvents, waste inks, cloths, paper, media, and other operating materials in covered fireproof containers.
• Place covered fireproof containers at least five meters away from the printer work area.
• Dispose of waste materials in accordance with local, state, province, or/and country government regulations.
• The presence of children or pets is forbidden at all times in or near the printer area.
2.2.7 Printing Media Handling and Precautions
The EFI Pro 24f printer is capable of using a wide variety of rigid media. Follow these precautions:
• Wear hand and foot safety protection gear when loading, unloading and handling media to avoid bodily injury.
• Use proper heavy-duty handling equipment if available.
2.2.8 High Voltage Dangers and Precautions
The EFI Pro 24f is safe to operate in its normal operating configuration. However, with key protective covers opened or
removed, electrical components carrying high voltage are exposed. The EFI Pro 24f carries high voltages that could cause
serious injury or death from electrocution. Only qualified service technicians may service the EFI Pro 24f Electrical
Systems. Follow these precautions:
• Verify provisions for emergency power off before connecting the printer to main power supply.
• When printer power is on, do not open any cover panel or touch any electrical components.
• All printer systems should be grounded in accordance with local electrical safety regulations per State, Province, Region, or Coun-
try codes. Ground voltage should be less than 3V.
• Set the printer on smooth tile or cement floor.
Document ID: OMM-00148 Rev. B
13
Advertisement
Table of Contents
