Maintenance And Cleaning; Outer Surface; Chamber - RoboLabs Grand Robopop 220 User Manual

6 Maintenance and cleaning

• ALWAYS UNPLUG equipment before cleaning or servicing.
• DO NOT USE excessive water or water jet for cleaning. DO NOT SPILL
water on electric panels or electric parts.
• Keep power cord and plug o the floor and water.
• Burn hazard! WAIT until cooled down before cleaning.
• DO NOT USE aggressive solutions, or sharp items, or abrasives for clean-
ing.
The purpose of maintenance and cleaning is to keep machine in good condition during all the
lifetime and to meet safety requirements. If machine is not used for long time, do all the clean-
ing procedures.
Recommended cleaning schedule:
Outer surface cleaning
Chamber cleaning, including mesh screen
Feeder cleaning

6.1 Outer surface

1. Unplug the machine.
2. Clean outer surfaces of the machine with a clean soft cloth or sponge dampened with
cleaning solution.
3. Wipe dry immediately.

6.2 Chamber

1. Open the chamber.
2. Remove unpopped kernels from the perforated bowl, (pos.1 Fig.2).
3. Remove dust from internal surfaces of the chamber with the means of soft dry clean cloth.
Avoid hard impact to the optical sensor, (pos.3 Fig.2).
4. Clean the mesh screen (pos.6 Fig.2) with a suitable brush or a vacuum cleaner.
5. If the mesh screen is heavily clogged with dust and scrap, then do the following:
(a) Remove the screws that hold the ba e (pos.5 Fig.2).
(b) Take the ba e out from the chamber.
(c) Clean the mesh screen.
(d) Put ba e back on its place and secure the fasteners.
DANGER
WARNING
CAUTION
every day
every day
every month
14