Intended Use; Installing The Refrigerator - Dometic RML9336 Installation Manual

Intended use

4 Intended use
The RML9336 refrigerator is designed for installation in caravans or motorhomes.
It is only suitable for cooling and storing foodstuffs. The refrigerator is not intended
for the proper storage of medicine.
!
WARNING! Health hazard!
Please check if the cooling capacity of the refrigerator is suitable for
storing the food you wish to cool.
The refrigerator is designed to be operated on a DC power supply and an AC socket
and can be independently powered by liquid gas (propane or butane). The refriger-
ator may not be run on natural gas or city gas.
5

Installing the refrigerator

5.1 Preparing the installation
When installing the refrigerator, note the following:
•
To enable the refrigerant to circulate properly, the refrigerator may not exceed an
angle of 3°.
To do this, park the vehicle on a level surface and check to see if the ice-cube tray
is flat in the refrigerator.
•
The refrigerator must be installed so that it is easily accessible for service work,
easy to de-install and install and can be easily removed from the vehicle.
•
The distance between the refrigerator and the rear wall must be at least 15 mm.
•
The refrigerator must be installed in a recess so that it stands firm when the vehicle
is in motion. Note the following dimensions here (fig. 1, page 2).
The outer wall must be fitted with an air inlet vent (fig. 2 1, page 2) and an outlet
•
vent (fig. 2 2, page 2) with ventilation grilles so that the heat generated can be
easily released to the outside:
– Air inlet vent: Fit the ventilation grille as flush as possible to the floor of the
installation niche with a minimum cross-section of 400 cm
– Outlet vent: fit as far above the refrigerator as possible.
– The distance between the air inlet and outlet vents must be at least 1050 mm
(fig. 3, page 2).
Fit a heat conduction plate (fig. 2 3, page 2) above the refrigerator so that the
•
heat does not accumulate in the vehicle.
12
RML9336
2
.
EN