Operating The Device Safely; Intended Use - Dometic EA 24B Short Installation And Operating Instructions

Operating the device safely

DANGER! Electrocution hazard
Failure to obey these warnings will result in death or serious injury.
Do not touch exposed cables with your bare hands.
WARNING! Fire hazard
Failure to obey these warnings could result in death or serious injury.
• Keep the ventilation openings in the device enclosure or in the built-in structure clear of ob-
struction.
• Do not use mechanical objects or other means to accelerate up the defrosting process oth-
er than those recommended by the manufacturer.
• Do not damage the refrigerant circuit.
• Do not use electrical devices in the compartments of the device unless they are recom-
mended by the manufacturer for the purpose.
CAUTION! Electrocution hazard
Failure to obey these cautions could result in minor or moderate injury.
• Before starting the device ensure that the power supply line and the plug are dry.
• Disconnect the cooling device from the power supply:
CAUTION! Health hazard
Failure to obey these cautions could result in minor or moderate injury.
• Check if the cooling capacity of the device is suitable for the storage of the drinks to be
cooled.
• Store only closed and still sealed bottles in the device.
• Opening the door for long periods can cause significant increase of the temperature in the
compartments of the device. If the device is le empty for long periods:
NOTICE! Damage hazard
• Never immerse the device in water.
• Protect the device and the cable against heat and moisture.
4

Intended use

The beverage storage appliance (also referred to as beverage center) is intended to be used exclusively for the
storage and temperature control of beverages. It is suitable as mobile outdoor built-in beverage center.
This beverage center is not intended to be used as a freestanding appliance.
Before each cleaning and maintenance
After every use
Switch off the device.
Defrost the device.
Clean and dry the device.
Leave the door open to prevent mold developing within the device.
17