Menu Operations - NEC PlasmaSync 42XR4 Operation Manual

OSM
(On Screen Menu)

Menu Operations

The following describes how to use the menus and the
selected items.
1. Press the MENU/ENTER button on the remote control to
display the MAIN MENU.
MAIN MENU
PICTURE
AUDIO
IMAGE ADJ.
SEL. MENU/ENTER
2. Press the cursor buttons
highlight the menu you wish to enter.
3. Press the MENU/ENTER button on the remote control to
select a sub menu or item.
PICTURE
PICTURE MEMORY
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
NR
COLOR TEMP.
CINEMA MODE
PICTURE MODE
SEL. ADJ.
MENU/ENTER
4. Adjust the level or change the setting of the selected item
by using the cursor buttons
CONTRAST
5. The adjustments or settings are then stored in memory.
The change is stored until another change is made.
6. Repeat steps 2 – 5 to adjust an additional item, or press
the EXIT button on the remote control to return to the
main menu.
* When adjusting using the bar at the bottom of the screen,
press the or button within 5 seconds. If not, the current
setting is stored and the previous screen appears.
Note: The main menu disappears by pressing the EXIT
button.
SET UP
FUNCTION
SIGNAL INFO.
OK EXIT EXIT
on the remote control to
: OFF
: 52
: 32
: 16
: 32
: 32
R G
: OFF
: MIDDLE
: ON
: NORMAL
OK RETURN
EXIT
on the remote control.
: 10
Controls
Information
Advanced menu mode
When "ADVANCED OSM" is set to "ON" in the
FUNCTION menu, full menu items will be shown.
PICTURE MEMORY
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
NR
COLOR TEMP.
CINEMA MODE
PICTURE MODE
GAMMA
LOW TONE
SET UP LEVEL
COLOR TUNE
SEL. ADJ.
* The actual screen may be different from the ones
in this manual.
En-16
PICTURE
: OFF
: 52
: 32
: 16
: 32
: 32
R G
: OFF
: MIDDLE
: ON
: NORMAL
: 2.2
: AUTO
: 0%
MENU/ENTER OK EXIT RETURN