Quick Start - NEC MultiSync LCD1880SX User Manual

Quick Start

To attach the MultiSync ®
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display
card in your system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB to DVI-A signal cable to the connector of
the display card in your system (Figure A.2).
For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the 15-pin
mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1).
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
3. Connect the DVI signal cable to the connector on the back of the monitor. Place the video signal cable
(Figure C.1). Connect only either VGA or DVI to input 2.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components
of LCD module and/or shorten the module's life.
Collect cables and keep them in the stand with attached wireclamps.Use 2 wireclamps for keep them in
the back stand (Figure C.1), or use 1 wireclamp for keep them in the front stand (Figure C.2).
Please check Tilt, Rise and Lower monitor screen and screen rotation when you manage cables.
4. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the
power outlet (Figure C.1).
NOTE: Use the supplied AC power cord. If it does not match the shape and the voltage of AC power
outlet being used, please refer to the Recommend Use section for proper use of the AC power cord.
5. The Vacation Switch on the left side of the monitor must be turned on. Turn on the monitor with the front
power button (Figure D.1) and the computer.
NOTE: There are two switches - one on the left side and on the front side of the monitor. DO NOT switch
on/off quickly.
6. To complete the setup of your MultiSync LCD monitor, use the following OSM
• Auto Adjust Contrast (Analog input only)
• Auto Adjust (Analog input only)
Refer to the Controls section of this User 's Manual for a full description of these OSM controls.
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual.
NOTE: Refer to User's Manual in the NEC LCD Setup Software CD case for installation and operation of
this software.
: Trademarks apply to appropriate countries.
*
* LCD monitor to your system, follow these instructions:
* controls :
®
8