Table of Contents
Advertisement
Quick Start
To connect the LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For a PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display controller in your
system (Figure A.1). Tighten all screws.
For a PC with Analog output (MDview 232/241 only): Connect a 15-pin mini D-SUB to DVI-A signal cable (not included) to
the connector of the display controller in your system (Figure A.2).
For a MAC (MDview 232/241 only): Connect a Macintosh cable adapter (not included) to the computer, then attach the
15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure A.3).
NOTE:
Some Macintosh systems do not require a Macintosh cable adapter.
For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display controller in your system
(Figure A.4).
Figure A.1
NOTE:
1. Please use a DisplayPort cable with a DisplayPort logo.
2. When removing the DisplayPort cable, hold down the top button to release the lock.
3. Height adjustment is locked by lock button. Place hand on top of the monitor to push down the screen to the lowest position.
Slide the lock button to unlock (Figure B.1).
NOTE:
Handle with care when unlocking stand.
Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position.
Slide the cable cover up (Figure B.2).
NOTE:
Cable cover is not removable.
Figure B.1
Macintosh Cable
Figure A.2
Adapter
(not included)
Cable cover
English-4
DisplayPort cable
Figure A.3
30° Tilt
Figure B.2
Figure A.4
Advertisement
Table of Contents
