Tele System PALCO LED09 Manual page 40

TELE System
8.1 Simple installation
For the single inverter antenna (LNB)/satellite with direct connection between the TV
and antenna, they DiSEqC commands or other special communication protocols are not
used.
8.1.1 Antenna and satellite configuration
From the Antenna setup menu make the following choices:
7. Satellite: Satellite choice of interest. Highlight the Satellite confirm by pressing OK
and press ►.
1. LNB type: Type of converter (Low Noise Block converter - LNB) associated to the
chosen satellite. For common satellite systems used in Italy, The Universal
(9750/10600) is used.
2. LNB supply: LNB power supply for switching between horizontal and vertical
polarization. Generally it must be maintained active (13 / 18V). Its inactivation is
rather useful when you realize IF-IF distribution plants (for Expert users).
3. 22KHz: 22KHz signal switching between high and low band
8. Tone burst: none
9. DiSEqC 1.0: none
10. DiSEqC 1.1: none
11. Motore: none
8.1.2 Channel search for satellite
After setting the configuration, to search channels on the chosen satellite press the BLUE
button Scan and define the following parameters in the Channel Search dialogue
window:
12. Scan type: scanning mode following the transponder database (default option) or
blind-scan frequency steps (Blind-Accurate option) or via network (network
option) that scans the active transponders.
13. Channel type: choose free to air channels to only search for free channels
(recommended), Encrypted only for encrypted channels or All to scan both types.
14. Service type: choose DTV to only search for TV channels, Radio to only search for
radio All
15. Press OK to start scanning.
12