Tele System PALCO LED09 Manual page 39

ENGLISH
7.3 Organization of channel list.
Press the MENU button; in CHANNEL menu, select the item Edit Program and confirm
with the OK button.
You will see the channel list with the following options available:
Red button (Delete): to delete one or more channels select the channel with the
UP/Down buttons and press the red button to confirm the cancellation.
Blue button (Skip): select the channel and press the Blue button; if activated, the channel
can only be displayed when recalled by using the number buttons on the remote.
Yellow button (Move): to move a channel, select the channel you want to move, press
the Yellow button, use the arrow keys to move the channel to the desired position or
enter the desired position number, then press OK to confirm.
7.4 Favorites list
You can create a favorite channels list for DTV channels (terrestrial signal): Once the
option Program Edit and the channel you want to add to the Favourites list has been
selected, press the FAV button; Repeat for each channel you want to add.
After you create the list, to access it, simply press the FAV button and select the
channel with the arrow keys UP/Down and OK to confirm.
You can later remove one or more channels by performing the same procedure,
selecting the channel you want to delete, and pressing the FAV button.
8 Satellite mode
To activate the digital channel reception mode, press the Source button, select Satellite.
You can scan the frequencies available with your satellite antenna system, automatically
searching for all the satellite channels from the first installation (see paragraph 6.8) or
through an automatic scanning available in the Channels menu.
Antenna setting: the basic settings to allow the use of the TV with a single Universal LNB
(Low Noise Block converter) system (commonly used for satellite systems in Italy); in the
event your system is done with a different configuration, you must appropriately change
the antenna settings.
ATTENTION!!!
The wrong antenna configuration can result in the failure to load some or all channels. If
you do not know the characteristics of your antenna system and/or are unable to
properly configure the receiver yourself, you may want to consult a professional installer
for advice. The power and signal quality indicators refer to the first transponder of the
chosen satellite list.
Changing the DiSEqC 1.0 / 1.1 parameters, DiSEqC 1.2 / DiSEqC 1.3, you will get three
different configuration modes.
11