Tele System PALCO LED09 Manual page 33

ENGLISH
USB port (Mediaplayer)
Component input (YPbPr, adapter not included)
RCA Video + Audio input (AV, adapter required)
4
Slot Common Interface (CI+)
COAXIAL audio output
HDMI3 input
HDMI2 input
3 Connections
3.1 Antenna connections/cable TV channel
To view the television channels, you can connect the TV to one of the following devices:
A terrestrial antenna and/or a satellite antenna system.
In either case, connect the antenna cable (75 Ω) to the coaxial jacks located in the rear
of the TV.
3.2 Connection to an external device
Via SCART: make sure that both the TV and the device are turned off. Connect the SCART
cable from the source to the TV. Turn on the two devices. Press the Source button on
the remote control and select SCART.
Via RCA: make sure that both the TV and the device are turned off. It is necessary to use
an RCA/Jack3.5mm adapter to connect the device to the AV/RCA input. Turn the two
devices on. Press the Source button on the remote control and select AV as the source.
Via YPbPr (Component): make sure that both the TV and the device are turned off. It is
necessary to use an RCA/3.5mm jack adapter to connect the device to the AV/RCA,
respecting the colors as per the following instructions:
Yellow - Green
Red - Red
White - Blue
Turn on the two devices.
Press the Source button on the remote control and select YPbPr.
Via HDMI: make sure that both the TV and the device are turned off. Connect the cable
from the source to the TV. Turn on the two devices. Press the Source button on the
remote control and select HDMI.
Not available, if SCART input has been substituted by RCA input
4
5