Mercedes-Benz CLS Operator's Manual page 354

Position socket 2 from the tyre-change tool
#
kit on hub cap 1.
Position wheel spanner 3 on socket 2.
#
Using wheel spanner 3, turn hub cap
#
anti-clockwise and remove it.
To fit:
Follow the instructions above in reverse order.
#
%
Specified tightening torque: 25 Nm.
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change ( page 350).
/
The wheel trims and hub caps have been
R
removed ( page 350).
/
Important notes on using the jack:
Use only a vehicle-specific jack that has been
R
approved by Mercedes-Benz to raise the vehi-
cle.
The jack is only designed for raising and hold-
R
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
work under the vehicle.
1
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large, flat,
load-bearing, non-slip underlay.
The foot of the jack must be positioned verti-
R
cally under the jack support point.
Wheels and tyres 351
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the vehi-
R
cle.
Never lie under the vehicle.
R
Do not start the vehicle and do not release the
R
electric parking brake.
Do not open or close any doors or the boot
R
lid.