Mercedes-Benz CLS Operator's Manual page 353

350 Wheels and tyres
1 Jack
2 Wheel wrench
3
Centring pin
4
Folding chock
5
Ratchet for jack
Preparing the vehicle for a wheel change
Requirements
The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
R
ground.
The required tyre-change tool kit is available.
R
%
If your vehicle is not equipped with the tyre-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Shift the transmission to position j.
#
Vehicles with level control system: set the nor-
#
mal vehicle level ( page 219).
/
Switch off the vehicle.
#
Make sure that the vehicle cannot be started.
#
Place chocks or other suitable items under the
#
front and rear of the wheel that is diagonally
opposite the wheel you wish to change.
If necessary, remove the wheel trim/hub caps
#
( page 350).
/
Raise the vehicle ( page 351).
/
#
Removing and fitting the wheel trim/hub caps
Requirements
The vehicle is prepared for a wheel change
R
( page 350).
/
Plastic hub cap
To remove:
Turn the centre cover of the hub cap anti-
#
clockwise and remove the hub cap.
To fit:
Make sure that the centre cover of the hub
#
cap is turned anti-clockwise.
Position the hub cap and turn the centre cover
#
clockwise until the hub cap engages physically
and audibly.
Aluminium hub cap
To remove: