Power On By Alarm - CHAINTECH CT- 6AIA Manual

I. Doze Mode
The Power Management function must not be set to disabled to enable this function.
If no interrupts have occured and the Doze timer expires, system will enter Doze
mode. In Doze mode, the CPU clock runs at a lower speed while all other devices
operate normaly.
Power saving modes achieved in lower power saving states will either be
maintained or enter higher power saving modes when switching to higher
power saving states. For example, the CPU clock will not switch back to
normal in Standby mode. It will maintain a decreased rate in Standby Mode
and turn off in Suspend Mode.
J. Suspend Mode
The Power Management function must not be set to disabled to enable this function.
If the system runs in Standby mode and the Suspend timer expires, all devices
regulated by power management will shut off and the CPU speed will be 0 MHz.
K. VGA
Enable this selection to set the LAN awakening the system function .
L. LPT & COM
When On of LPT & COM, any activity from one of the listed system peripheral
deveces or IRQs wakes up the system.
M. HDD & FDD
When On of HDD & FDD, any activity from one of the listed system peripheral
deveces wakes up the system.
N. DMA/Master
When you are On DMA/ISA Master, any activity from one of the listed system
peripheral deveces or IRQs wakes up the system.
O. Wake Up On LAN
Enable this selection to use the Wake Up On LAN function discussed in Section
2-4 of this manual.
P. Power On By Alarm
When enabled, this setting allows the system to turn back on at a designated
time of the month. User must designate date of month and time of day. This
function is only available when using an ATX power supply and the Software
Power-Off function to turn off the computer. See the Software Power-Off feature
in Section 2-4 of this manual for instructions.
Award BIOS Setup Program
35