CHAINTECH CT- 6AIA Manual page 47

User's Manual
B. Init Display First
This function allows user to choose between AGP slot or VGA slot to initialise
Display first .
C. Onboard Sound Chip
This function must be enabled in order to use the onboard audio function. To
terminate this function set it to disable.
D. Power On By Keyboard
Set to Disabled to control your computer's power by the button on your system
case. Set this function to Any Key to turn on the computer by touching any
key on the keyboard. If you set this function to Hot Key or Password you must
designate the keystrokes that will turn on the computer.
E. Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install an add-in FDC or the system
has no floppy drive, select Disabled in this field.
F. Com2 Mode
When set to Enabled, the COM port will be redirected to support IR function.
G. Onboard Parallel Port
Select a logical LPT port address and corresponding interrupt for the physical
parallel port.
H. Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select Normal,
Compatible, or SPP unless you are certain your hardware and software both support
one of the other available modes
I. Power Failure Recovery
Computers using an ATX power supply do not turn back on after the power source
to the computer unexpectedly fails (i.e. electricity outage). Enabling this setting
will allow the system to always turn back on after a power failure. This is especially
important for computers that must be on 24 hours per day.
42