Advertisement
Set-up Instructions
Now that you have your new Kurt Vise, it's time to set-up and begin
using it. You will see that your new vise comes with a Kurt swivel
handle, chip guard and instruction manual in the shipping carton. The
chip guard rests between the ways of the vise and can be trimmed to
size to help keep the chips out of the screw. The handle is specifically
designed to provide maximum torque to your vise. Your vise should
be mounted to a clean, flat surface. The surface and the vise must be
free of any chips, dirt or debris of any kind. The mounting surface can
be honed if necessary. Clean the bottom of the vise with solvent or
other cleaner if needed.
To minimize vise bed deflection, clamp your Kurt vise to your machine
table, pallet, or sub-plate using the built-in clamping slots provided.
Additional clamping can be used, but may not be necessary. Please
be sure to exercise good judgment when securing your vise to the
mounting surface. Be sure your vise is secured and will not move when
applying the machine pressure.
Manual Vise Clamping Force
Torque Ft.-Lbs.
4
ENGLISH |
Set-Up Instructions
10
20
30
40
50
60
70
80
D40
1129
2242
3337
4148
5379
6310
6977
7968
Advertisement
