Table of Contents
Advertisement
SET-UP INSTRUCTIONS
Now that you have your new Kurt Vise, it's time to set-up and begin using it.
You will see that your new vise comes with a Kurt swivel handle and chip
guard in the shipping carton (instruction manual available online at
www.kurtworkholding.com). The chip guard rests between the ways of the
vise and can be trimmed to size
from the screw. The handle is specifically designed to provide maximum
torque to your vise (clamping force provided below). Your vise should be
mounted to a clean, flat surface. The surface and the vise must be free of
any chips, dirt, or debris of any kind. The mounting surface can be honed if
necessary. Clean the bottom of the vise with solvent or another cleaner if
needed.
To minimize vise bed deflection, clamp your Kurt vise to your machine table,
pallet, or sub-plate using the built-in clamping slots or through the body
holes provided.
Additional clamping can be used, but may not be necessary. Please be sure
to exercise good judgment when securing your vise to the mounting surface.
Be sure your vise is secured and will not move when applying the machine
pressure.
Torque Ft.-Lbs.
4
(see pg. 10)
3400V/3410V
10
20
30
40
50
60
SET-UP INSTRUCTIONS
to help keep the chips away
Clamping Force (Lbs.)
1050
2200
3450
4650
6250
7500
Advertisement
Table of Contents
