Zodiac Z250 Instructions For Installation And Use Manual page 41

1.3.2 Cable cross section
• Open the top panel ( ) with a screwdriver (4 screws) to access the electrical terminal block.
• Insert the power supply cable (
• Inside the appliance, fix the power supply cable by threading it through the cable clamp (
screw).
• Connect the power supply cable to the terminal block inside the appliance as following.
Terminal block for single-phase power
• Carefully close the top panel.
) into one of the cable gland (
Accessing the electrical terminal block
Connect options
Connect to
(filtration pump,
power supply
power supply relay),
(220-240V
see"1.4 I Option
50-60Hz)
connections".
) on the rear part of the appliance.
L: Live
N: Neutral
: Earth
) (maintained with one
EN
10