Tools required for assembly and service may not be included. For technical questions or replacement parts, please call 1-800-444-3353. Revised Manual 10c Model 96289 ® . All rights reserved. No portion of this manual or any artwork...
SKU 96289 For technical questions, please call 1-800-444-3353. NOTicE is used to address practices not related to personal injury. cAUTiON, without the...
Page 3
Carrying power tools with your finger on the switch or energizing power tools that have the switch on invites accidents. SKU 96289 For technical questions, please call 1-800-444-3353. Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations.
Hidden areas behind walls, ceilings, floors, soffit boards, and other panels may contain flammable materials that could be ignited by the heat gun when working in these locations. The ignition of these materials may not be readily apparent and could result in property damage and injury to persons.
Page 5
They will be hot enough to cause burns during use and immediately afterwards. Do not use the Heat Gun on glass. Do not use the Heat Gun as a hair dryer or to heat up materials that can be damaged by high temperatures.
Page 6
To reduce your exposure to these chemicals: work in a well ventilated SKU 96289 For technical questions, please call 1-800-444-3353. area, and work with approved safety equipment, such as those respirators that are specially designed to filter out microscopic particles.
The plug and outlet should look like those in the preceding illustration. (See 3-Prong Plug and Outlet.) SKU 96289 For technical questions, please call 1-800-444-3353. Double insulated Tools: Tools with Two Prong Plugs Outlets for 2-Prong Plug Tools marked “Double Insulated”...
Page 8
16.1 – 20.0 * Based on limiting the line volt- TABLE A age drop to five volts at 150% of the rated amperes. SKU 96289 For technical questions, please call 1-800-444-3353. n 0 xxxx/min. (120/240 VOLT) LENGTH 75’ 100’ 150’...
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. SKU 96289 For technical questions, please call 1-800-444-3353. Product Applications When observing the safety rules, this Heat Gun is designed for all applications with hot air that are listed below: •...
(OFF) position. Then plug Power Cord (1) into the nearest 120 volt, grounded, electrical outlet. See Figure A. To turn on the Heat Gun, set its Power Switch (3) to “l” or “ll”. See Figure A. • Switch “l” - Low temperature position (572°...
Heat Element (11) properly to extend the life of the Heat Gun.) cAUTiON! Danger of fire. to set the Heat Gun on a non-flammable surface until it has completely cooled. Once cooled, store the Heat Gun in a clean, dry, safe location out of reach of children and other unauthorized people.
Note: If product has no serial number, record month and year of purchase instead. Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. SKU 96289 For technical questions, please call 1-800-444-3353. PARTS LiST Q’ty...
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 SKU 96289 For technical questions, please call 1-800-444-3353. LiMiTED 90 DAY WARRANTY Page 14...