Advertisement
5.
Before installing the tire pressure sensor, clean the
mating surface on the sensor and the aluminum
wheel.
GROMMET
VALVE
STEM
SENSOR
HOUSING
SURFACE
TIRE
PRESSURE
SENSOR
WHEEL
CENTER
ALUMINUM
WHEEL
TIRE PRESSURE
PROTRUSION
SENSOR
OF WHEEL
VIEWED FROM THE INSIDE
OF THE ALUMINUM WHEEL
6.
Install the tire pressure sensor and the washer on
the aluminum wheel and tighten the valve nut finger
tight. Make sure the pressure sensor is resting on the
wheel.
7.
While holding the tire pressure sensor against the
wheel to seat the grommet, torque the valve nut to
4 n·m (3 lb-ft).
NOTE: Install the tire pressure sensor so that sensor
housing surface should not exceed protrusion of
wheel to prevent the sensor housing caught to the
bead of the tire when assemble the tire.
© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
WASHER
VALVE
NUT
OUTSIDE
WASHER
VALVE NUT
Tightening torque:
4 N·m (0.4 kgf·m, 3 lbf-ft)
SENSOR HOUSING
SURFACE
NOTE:
• Do not reuse the grommets that had been tightened,
even one time, to the specified torque, as they are
deformed inside.
• Do not use pneumatic or electric tools on the valve nut.
• Tightening the nut above the specified torque can
damage the grommet.
• Make sure that there is no space between the sensor
and the wheel.
8.
Install the tires according to the instructions in the
Service Manual.
9.
Install wheels on the vehicle and torque the wheel
nuts to 108 N·m (80 lbf·ft).
771211AX
AII 37562 (0709)
3 of 9
Advertisement
