Table of Contents
Advertisement
Chapter 1 – IP Commands
#IPDEFGW – Default Gateway
Description:
Sets the default gateway address. The view command shows whether the address is
statically configured or obtained from the DHCP server.
Syntax:
Set Value: AT#IPDEFGW=<value>
View Value: AT#IPDEFGW?
Values:
IP address in dotted decimal notation (xxx.xxx.xxx.xxx)
Default
Value: 192.168.1.1
#IPDHCP – DHCP Client
Description:
Enables or disables DHCP client. If DHCP client is enabled, the module will take the IP
address from the DHCP server. If DHCP client is disabled, the module will take the static
IP address configured for the module. The view command shows whether the address is
statically configured or obtained from the DHCP server.
Syntax:
Set Value: AT#IPDHCP=<value>
View Value: AT#IPDHCP?
Values:
1: enable
0: disable
Default
Value: 0: disable
#IPADDR – Static IP Address
Description:
Sets the local static IP address. The view command shows whether the address is
statically configured or obtained from the DHCP server.
Syntax:
Set Value: AT#IPADDR=<value>
View Value: AT#IPADDR?
Values:
IP address in dotted decimal notation (xxx.xxx.xxx.xxx)
255 is Maximum Value in an Octate
Default
Value: 192.168.1.100
#IPNETMASK – Subnet Mask
Description:
Sets the subnet mask.
Syntax:
Set Value: AT#IPNETMASK=<value>
View Value: AT#IPNETMASK?
Values:
IP address in dotted decimal notation (xxx.xxx.xxx.xxx)
255 is maximum value in an Octate
Default
Value: 255.255.255.0
#IPDNSSERV1 – DNS Server 1
Description:
In order to translate the server names from literal format into IP addresses, the TCP/IP
stack software implements the Domain Name System (DNS) protocol. The DNS Server
IP address must be specified for use by the TCP/IP stack software.
Syntax:
Set Value: AT#IPDNSSERV1=<value>
View Value: AT#IPDNSSERV1?
Values:
32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx)
Default
Value: 202.56.215.6
Multi-Tech Systems, Inc. AT Commands for the MT800SWM & MTS2WFA (S000425D)
Chapter 1 – IP Commands
6
Advertisement
Table of Contents
