Table of Contents
Advertisement
Chapter 2 – PING Commands
#PINGNUM – Number of PING Requests
Description:
This command sets the number of PING echo requests to issue to PINGREMOTE.
Syntax:
Set Value: AT#PINGNUM=<Value>
View Value: AT#PINGNUM?
Values:
From 1 to 255 inclusive
Default
Value: 20
#PINGREMOTE – IP Address of Remote Device
Description:
This command sets the IP address of remote device to PING.
Syntax:
Set Value: AT#PINGREMOTE=<IP Address>
View Value: AT#PINGREMOTE?
Values:
32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx)
Default
Value: 192.168.1.1
#PINGSTART – PING
Description:
Directs the module to start PING requests to the configured PING remote address. The
number of requests to be sent is obtained from the PINGNUM
Syntax:
Set Value: AT#PINGSTART
Values:
PINGNUM
PINGREMOTE
Default
Value: None
#PING? – PING Module
Description:
Displays PING module related information.
Syntax:
AT#PING?
Values:
PINGNUM
PINGREMOTE
Default
Value: None
Multi-Tech Systems, Inc. AT Commands for the MT800SWM & MTS2WFA (S000425D)
Chapter 2 – PING Commands
command.
9
Advertisement
Table of Contents
