Wall-Mount Transformer; Memory Module - ESI IVX S-Class Installation Manual

IVX S-Class Installation Manual
Port card
There is only one port card type available for S-Class. The 482 port card is equipped with a standard
female amphenol connector for easy wiring to a standard 66 or 110 block. The S-Class 482 port card
cannot be used on any other ESI phone system.
Warning: 482 port cards for IVX 42s (Generation I) are not compatible with IVX 56s (Generation II); use only
port card boards marked 5010-0579 with S-Class main boards marked 5010-0578 or 5010-0590.
The 482 port card provides circuits to connect up to four loop-start CO lines, eight Digital Feature Phones,
and two analog station ports. The CO line ports support standard CO and Centrex loop-start lines;
ground-start CO lines are not supported. The analog ports provide a standard 24-volt, two-wire connection
to fax machines, analog phones, and modems. Only one analog device can be connected to each
analog station port. This card uses ten station ports and four CO ports when installed.
Notes: The S-Class main board comes in a four-line, eight-digital station, two-analog port configuration.
You can add either two
have the following configurations.
— 4 8 2: Base Cabinet (main board only)
— 8 16 4: Base Cabinet with one 482 port card.
— 12 24 6: Base Cabinet with one 482 port card and an Expansion Cabinet with one 482 port card.
— 16 32 8 (Generation II only): Base Cabinet with one 482 port card and an Expansion Cabinet with
two 482 port cards.
Also: the system must contain at least one 482 port card to access both conference bridges.

Wall-mount transformer

The System Cabinet requires a three-amp transformer (supplied).

Memory Module

3
The Memory Module consists of either a CompactFlash
Module contains all system programming and configuration data, including pre-loaded voice prompts.
Its voice storage capacity depends on how many voice mail ports the system has: on a four-port
system, the Memory Module provides six hours; and, on a six-port system, it provides 30 hours.
1
IVX S-Class Generation I.
2
IVX S-Class Generation II.
3
Memory Modules are packaged separately and are mounted in the cabinet during installation.
B.2
1 2
or three 482 port cards on an S-Class system. Therefore, the system can
Hardware overview/installation
®
card or a hard disk drive. The Memory