Opening The Cabinet; Mounting The Cabinet - ESI IVX S-Class Installation Manual

IVX S-Class Installation Manual

Opening the cabinet

The lid on all cabinets is held in place by two tabs that rest in slots in the bottom
of the case, and a release tab that snaps into an opening in the top-center of
the cabinet and is secured by a retaining screw.
To remove the lid:
1. Remove the retaining screw and depress the release tab at the top of
the cabinet.
2. Rock the lid back from the top.
3. Lift and pull the lid free from the slots in the bottom of the cabinet.

Mounting the cabinet

Use three Phillips-head screws (provided). Note the position of the
three mounting holes in IVX.
1. Screw in the top screw to the backboard — at least
one-half-inch-thick plywood — leaving about one-eighth-inch
clearance between the screw head and the plywood.
2. Hang the unit using the keyhole at the top of the case.
3. Level the unit and install the bottom two screws.
Attach the power transformer to the wall, allowing sufficient length
in both cords to reach the power connector on the upper right side
of the cabinet and to reach a UPS or a dedicated 110 VAC outlet.
Hardware overview/installation
B.7