Setup - WAGNER POWER PAINTER Owner's Manual

Setup

Start
You will need:
• Lubricant
Note: The cup will give you
approximately 3-5 minutes of
continuous spraying time.
ImpoRTANT: Avoid running the cup dry.
An empty cup will allow air to become
sucked into the sprayer, which leads to
globbing and spitting.
1
1. Remove the cup.
4
4. Insert the suction tube into the
intake opening.
Note: Make sure the suction tube is
inserted as far as it will go to ensure
a tight fit.
5
2
2. Fill the container with the
material to be used.
(1)
(2)
Note: If you are going to be spraying
up, point the suction tube opening (1)
toward the rear of the gun.
If you are going to be spraying down,
point the suction tube opening (2)
toward the front of the gun.
3
(a) (b)
3. Place a few drops of lubricant
down the intake (a) and return
openings (b) in the pump
housing.
5
5. Thread the container securely
to the sprayer. Plug in the
sprayer.
English English