Cleanup - WAGNER POWER PAINTER Owner's Manual

Cleanup

You will need:
Start
• Waste container
• Warm soapy water if you sprayed latex
materials
• Mineral spirits if you sprayed oil-based
materials
make sure you clean the sprayer in a
well-ventilated area whenever
cleaning with flammable solvents.
The sprayer contains electrical parts.
Do NoT submerge the sprayer into
any liquids.
5
5. Slide the pump housing
off the sprayer.
1
1. Unplug the sprayer.
Pour the remaining
material back into the
original container.
Rinse the inside of the
cup with the appropriate
cleaning solution.
6
6. Remove all parts from the pump housing
assembly.
Clean all parts thoroughly with the brush
provided using a solution appropriate to the
type of material you sprayed.
2 3
2. Remove the suction 3. Turn the spray tip
tube. counterclockwise until
it is removed.
Pull the atomizer valve
out, being careful not to
lose it.
7
7. ImpoRTANT: make sure to
completely remove all material
from the inside of the piston
chamber by scrubbing with the
brush. even a small amount of
material can dry like glue and
keep the piston from moving,
causing damage to the sprayer.
9
4
4. Using the spray tip,
turn the locking nut
counterclockwise until
it is removed.
8
(a)
8. ImpoRTANT: make sure to keep
the vent hole (a) on the pump
housing clean and unblocked
or a vacuum can build up in the
container and cause damage
to the sprayer. A toothpick or
straightened paper clip can be
used to clean it.
English