Trane Tracer UC400 Installation, Operation And Maintenance Manual page 2

Introduction
N N o o t t e e : : Specific reference to either UC400 or UC400–B is made throughout this document. All
The UC400/UC400-B is a multi-purpose, programmable (or application-specific controller) that
provides direct-digital zone temperature control. The controller can operate as a stand-alone
device or as part of a building automation system (BAS). Communication between the controller
and a BAS occurs on an open standard with inter-operable protocols used in Building
Automation and Control Networks (BACnet®). Programming is done by means of the Tracer® TU
service tool.
This guide provides installation and configuration information for the UC400 Controller with
specific operation description for Blower Coil, Fan Coil, and Unit Ventilation.
Refer to the Resource section for documentation related to concepts discussed throughout this
manual.
Copyright
This document and the information in it are the property of Trane, and may not be used or
reproduced in whole or in part without written permission. Trane reserves the right to revise this
publication at any time, and to make changes to its content without obligation to notify any
person of such revision or change.
Trademarks
All trademarks referenced in this document are the trademarks of their respective owners.
Agency Listings and Compliance
The European Union (EU) Declaration of Conformity is available from your local Trane® office.
Revision History
Corrected Face/Bypass terminations in
©2020 Trane
other content cited in this document about the UC400 is referred to as U U C C 4 4 0 0 0 0 C C o o n n t t r r o o l l l l e e r r .
Figure 6, p. 23 and Figure 12, p. 29
BAS-SVX48H-EN