Air Filter - EcoFlow Smart Generator Dual Fuel User Manual

3.4 Air Filter

1. Turn the maintain cover knob to
2. Take off the screws and the air filter cover.
3. Take off the foam filter element.
4. Clean the foam filter element with soapy water or a nonflammable solvent
and dry it.
5. Add oil to the foam filter element and squeeze out the excess oil. The
foam filter element should be wet but should not drip any oil.
6. Place the foam filter element into the air filter.
Tips: 1. Make sure that the surface of the foam filter element is in close
contact with the air filter, leaving no gap between them.
2. Do not start the generator before reinstalling the air filter as excessive
toxic gas may be produced and foreign objects may enter the engine,
causing wear to the engine block.
7. Install the air filter cover back to its original position and tighten the screws.
8. Reinstall the maintenance cover and turn the knob to Closed.
Caution
Do not twist the foam filter element, to prevent any damage to it.
Wash clean
and take off the maintenance cover.
Press and air dry
(do not twist)
Removing the air filter cover
Add correct
amount of oil
Press (do not twist)
19