Table of Contents
Advertisement
Inserting a Glue Stick
1. Insert one glue stick into the opening (5) of the glue gun and
push it in as far as you can.
2. Press the trigger to make sure that the stick is solidly pressed
against the heater unit.
Operation
1. Connect the unit to a power outlet.
The glue gun immediately starts to
heat up.
2. Set the glue gun on its wire support
(4) and wait until some glue is
molten and appears in the nozzle.
When the trigger (3) is pressed
molten glue is forced out of the
nozzle.
3. Put some molten glue onto the dry,
clean surface you want to use and
immediately press the work piece
you want to glue down into the
molten glue. The glue solidifies
almost immediately and forms an instant bond.
After use molten glue can remain in the glue gun, it will be melted
again when the unit is used the next time.
Operation
8
Advertisement
Table of Contents
