Control Panel; Accessories - GE Diamond Operation Instructions Manual

3 Preparations for operation
Switching ON and OFF restores the default settings on the control panel. It
is recommended that you allow a warm-up period of approximately 3
minutes after the unit is switched on.
3.3 C
ONTROL PANEL
Diamond's control panel uses
an LCD-display and
segment LED displays for
status information display
and has various buttons to
regulate the functions of the
X-ray unit.
The control panel can be
attached to the radiation
shield or to the wall. Exposure
can be initiated only from the
control panel exposure
button. Use of the function
buttons depends on the
menu display and required
functions. These buttons are
used to choose various
imaging modes, to select the
Integrated Quality Control
(IQC) function and date, time
and hospital information
input.
Use the Cancel button to go
back one step in the menu
without selecting an option
or to cancel a selection. Use
the SET button to accept
selections and to proceed to
the next step in the menu. The exposure button initiates the exposure
signal to the computer, but when it is released, the hardware inhibits the
exposure. The use of the LCD-display and control panel interface in
service and setup modes speeds up the installation and service.
3.4 A
CCESSORIES
A usual Diamond unit delivery includes:
– Diamond unit
– Buckies and paddles according to order
– Two foot pedals

– Control panel

– Operating instructions
The following accessories are available for the unit (refer to Diamond
Accessory Catalog (86503-IMG) for complete listing of accessories and
order codes). Choose the accessories necessary to your procedures:
10
7-
GE Healthcare 86500-IMG rev 3