Imperx Cheetah 3G-SDI User Manual page 41

Cheetah Pregius Camera User Manual | 3G-SDI Interface
Command Terminal
The Command Terminal shows information about all commands sent to or received by the
camera. It also lets you communicate directly with the camera by entering write or read
commands directly into the text box on the Command Terminal screen.
To write a command to a camera register, the command terminal must send a sequence of 7
bytes to the camera. The write command must start with 0x followed by 57, the register
address, and data.
Example 1:
Write to register address 0x0410, data value = 0x11223344:
Camera Write Command: <0x57> <04> <10> <11> <22> <33> <44>
To read a command from a camera register, the command terminal must send a sequence of 3
bytes to the camera. The read command must start with 0x followed by 52 and the register
address.
Example 2:
Read from register address 0x0410:
Camera Read Command: <0x52> <04> <10>
Disable Polling:
Polling Time:
Disable Error Checking:
April 14, 2021
turns polling commands on or off for frame time, exposure
time, frame rate, and so on.
You can change the polling time in milliseconds by entering a
number in the Polling Time field.
The software displays error messages when the camera returns
a command error. You can disable error checking by selecting
the Disable Error Checking check box.
Page
41 of 99
Rev 1.4