Install Power Supply - Cisco NCS 1004 Manual

Install Cisco NCS 1004 Modules
Figure 3: Installing the 1.2T, 1.2TL, 2-QDD-C, and QXP-K9 Line Cards
1 Support the line card with your hand at the bottom, while installing (or removing) a line card.
2 Use the fiber management bracket for holding the line card.
Use the fiber management brackets only for pulling out while removing or pushing in the card while installing
Caution
line cards or filler cards. Do not use the fiber management brackets to carry the cards. Always support the line
card (or filler card) at the bottom with your hand.
Step 6
Slide the line card completely inside, into the card guide.
Step 7 Using the Torx screwdriver, tighten the two M3, T15 Torx screws of the line card, to a torque value of 0.65 N-m.

Install Power Supply

This task has information about installing the PSUs into the NCS 1004 chassis.
Step 1 Orient the PSU correctly before inserting. Check for the This Side Up label.
Step 2
Using the handle, slide the PSU into the slot (support the PSU at the bottom with your hand) and push it in until you hear
a click sound; direction of insertion is shown in the following figure. The click sound indicates that the unit has been
latched (the locking latch needs to pressed and released only for removing the PSU).
Install Power Supply
Install Cisco NCS 1004 Modules
9