Safety Information - Kampmann 148941 User Manual

1.96
Climate Controller Type 148941 / Type 148942 / Type 148943 / Type 148944
Operation manual

3 Safety Information

Only allow a qualified electrician to perform installation, assembly and
maintenance work on electrical units in compliance with VDE guidelines.
Wiring should comply with the applicable VDE regulations and provisions
laid down by the regional electricity providers. Non-compliance with the
regulations and operating instructions can result in the units malfunctioning
with consequential damage and danger to people. There is a danger of fatal
injury caused by wires being swapped due to incorrect wiring! Disconnect
all parts of the system from the mains power supply and prevent them from
being reconnected before starting any connection and maintenance work!
Please read these instructions in full to ensure correct and proper
installation and the correct operation of the Climate Controller.
Please note the following safety-relevant information:
Protect the products from any moisture during installation. Check the use
with Kampmann GmbH in case of any doubt. Any use other than the use
specified above is deemed not to be correct and proper. The operator of
the unit is solely responsible for any damage arising as a result of this.
Intended use is deemed to include observing the installation instructions
described in these instructions.
Modifications to the Unit
Do not undertake any modifications, conversions or additions to the control
unit or attachment parts without discussing them with the manufacturer as
they could impair the safety and operation of the unit. Do not carry out any
measures on the unit not described in this manual. Make sure that on-site
systems and cabling are suitable for connection to the intended system!
•
Disconnect all parts of the system that are being worked on.
•
Ensure that the system cannot be accidentally re-connected!
•
Before commencing installation/maintenance work, wait until the
fan has come to a standstill after the unit has been switched off.
•
Caution! Pipes, casings and fittings can become very hot or very
cold depending on the operating mode!
•
Qualified personnel must have undergone training to provide them
with adequate knowledge of the following:
o safety and accident prevention regulations
o guidelines and recognized technical regulations, i.e.
Association of German Electricians (VDE) regulations
o DIN and EN standards
o accident prevention regulations VBG, VBG4, VBG9a
o DIN VDE 0100, DIN VDE 0105
o EN 60730 (Part 1)
o technical wiring regulations (TABs) issued by the regional
electricity providers
5