Controller - Kampmann 148941 User Manual

1.96
Climate Controller Type 148941 / Type 148942 / Type 148943 / Type 148944
Operation manual
8.2.3 Heating threshold values
Stage 1
Stage 2
Stage 3
8.2.4 Cooling threshold values
Stage 1
Stage 2
Stage 3

8.3 Controller

It provides the option of adapting general temperature control parameters and
specific control functions for heating and cooling mode. The following
parameters can be altered in the "Controller" "General" menu:
Hysteresis:
Start-up mode:
Neutr. zone 4-p
Standby
ECO setback
ECO boost
Presence/Eco
Release of fan actuation up to 20% when the configured temperature
is exceeded.
Release of fan actuation up to 60% when the configured temperature
is exceeded.
Release of fan actuation up to 100% when the configured temperature
is exceeded.
Release of fan actuation up to 20% when the configured temperature
is transgressed.
Release of fan actuation up to 60% when the configured temperature
is transgressed.
Release of fan actuation up to 100% when the configured temperature
is transgressed.
Switching-on and off hysteresis for the heating and cooling valve.
(refer to chapter 5.3 for the effect)
This parameter specifies the controller mode after a restart of the unit.
In 4-pipe mode, the heating and cooling setpoint is calculated
depending on the neutral zone.
Heating setpoint = setpoint – (Neutr. zone 4-p / 2)
Cooling setpoint = setpoint + (Neutr. zone 4-p / 2)
If the unit is in standby mode, the setpoint for heating mode is reduced
by the set parameter. In cooling mode, the setpoint is increased
accordingly.
In ECO mode, the setpoint for heating mode is lowered by the
parametrised value.
In ECO mode, the setpoint for cooling mode is raised by the
parametrised value.
This parameter is used to define the interaction between the presence
function and ECO mode:
Hold: ECO mode is enabled/disabled independently of the occupied
status.
17