Unit; Screen - Kampmann 148941 User Manual

1.96
Climate Controller Type 148941 / Type 148942 / Type 148943 / Type 148944
Operation manual

8.6 Unit

General settings for the Climate Controller can be entered in 'Unit Settings'.
Status after Power On
Values after Power On
Language
Lighting
Filter
Factory settings

8.7 Screen

8.7.1 Home screen
Various display values can be configured in the home screen of the LCD.
There is an option to display:
•
•
•
•
8.7.2 Header
The date and time can also be shown in the header as well as the information
symbols.
8.7.3 Footer
Up to five icons can be displayed in the footer bar.
The Climate Controller assumes a defined state after the power supply
has been switched on depending on this parameter.
This parameter describes whether the set values are maintained or
reset after a power reset.
There is an option to choose between German and English.
The brightness of the LCD display during operation and that of the ring
LED can be adjusted independently of each other.
A counter ("Filter alarm" parameter) can be enabled in the Filter menu,
which enables a filter message following expiry of the parametrised
weeks. The counter can be reset in the same menu. The counter is
activated as soon as it is > 0.
This function is used to reset the parameters to the factory settings.
the base setpoint ± offset
the offset
the temperature
nothing.
The power reserve to store the time and date is dependent on the
operating time of the control panel. The time should therefore be
set at the end of commissioning.
Fan stage (visible as standard)
Active timer channel (visible as standard)
Heating / cooling (visible as standard)
Presence (not visible as standard)
Window contact / dewpoint (not visible as standard)
22