Statement 5:
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
The server can be turned off in any of the following ways:
v You can turn off the server from the operating system, if your operating system
v You can press the power-control button to start an orderly shutdown of the
v If the operating system stops functioning, you can press and hold the
v The service processor can turn off the server as an automatic response to a
v You can turn off the server through a request from the service processor.
Internal connectors, LEDs, and switches
The illustrations in this section show the LEDs, connectors, and switches (buttons)
on the internal boards. The illustrations might differ slightly from your hardware.
supports this feature. After an orderly shutdown of the operating system, the
server will be turned off automatically.
operating system and turn off the server, if your operating system supports this
feature.
power-control button for more than 4 seconds to turn off the server.
critical system failure.
7
Chapter 1. Introduction