Furuno FE-800 Operator's Manual page 5

CAUTIO CAUTION
Handle the LCD carefully.
The LCD is made of glass, which can
cause injury if broken.
Do not transmit with the transducer
out of water.
Damage to the transducer can result.
Properly adjust the gain.
Too little gain gives no picture. Too much
gain shows excessive noise on the
picture. Using the depth data for naviga-
tion when the gain is incorrectly set can
lead to a dangerous situation.
Too high Correct
The data presented by this equipment
is intended as a source of navigation
information.
The prudent navigator never relies
exclusively on any one source of naviga-
tion information, for safety of vessel and
crew.
The use of two transceivers with
the same frequency will result in
interference.
When fitting more than one transceiver,
ensure the frequencies are different.
Warning Label(s)
Warning label(s) is(are) attached to the
equipment. Do not remove the label(s). If a
label is missing or damaged, contact a
FURUNO agent or dealer about replacement.
Too low
iii
SAFETY INSTRUCTIONS
CAUTION CAUTIO
Observe the following compass
safe distances to prevent
magentic compass deviation:
Standard
Compass
Display Unit
0.75 m
FE-8010
Transceiver Unit
1.50 m
FE-8020
Matching Box
0.80 m
MB-502
Matching Box
0.65 m
MB-504
About the TFT LCD
The TFT LCD is constructed
using the latest LCD techniques
and uses 99.99% of its pixels.
The remaining 0.01% may drop
out or blink, however this is not
an indication of malfunction.
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
Name: Warning Label 1
Type: 86-003-1011-3
Code No.: 100-236-233
Steering
Compass
0.50 m
0.95 m
0.50 m
0.40 m