Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ronix 8590
Summary of Contents for Ronix 8590
- Page 1 CORDLESS SCREWDRIVER 8590...
- Page 2 SPECIFICATION Model 8590 Voltage 3.6V Battery Capacity 850mAh No-load Speed 220RPM Charging Current Charging Time Use Time 45min Torque Max 1.0 Nm Weight 143g Charger USB/Type-C Charger Cable Zipper Box Accessories 75mm Bits:2 pcs (SL6,PH1) 25mm Bits:6 pcs (PH1,PH2,SL4,SL5,T10,H4) Extension Bar 1pc...
- Page 3 INTRODUCTION please read this instruction manual thoroughly before starting and ensure you are familiar with the operation of your new cordless screwdriver. It contains important information regarding the safety, assembly and operation of this product. Please keep this manual available to all users during the entire life of the screwdriver.
- Page 4 Damaged or entangled cords increase the risk of electric shock. - When operating a power tool outdoors, use an extension cord suitable for outdoor use. The use of a cord suitable for outdoor use reduces the risk of electric shock. PERSONAL SAFETY - Stay alert, watch what you are doing and use common sense when operating a power tool.
- Page 5 Use of the power tool for operations is different from those intended could result in a hazardous situation. SERVICE a. For any repair your product need, please call Ronix service center. OPERATING INSTRUCTIONS TO CHARGE THE BATTERY NOTICE:Charge before first use. The screwdriver is shipped partially charged;...
- Page 6 WARNING! Do not use the screwdriver while charging, it may cause damage to the battery. INSTALLING AND REMOVING BITS CAUTION: To avoid possibly serious injury, take care not to activate the forward/ reverse switch when installing or removing bits. 1.To install a screwdriver bit, install the bit in the keyless chuck. Long bits can be installed directly into the keyless chuck, while short bits are recommended to be inserted into the extension bar first, and then the extension bar with the short bit is inserted into the keyless chuck.
- Page 7 2.Check to make sure that the bit is securely installed. 3.To remove the screwdriver bit, pull the screwdriver bit from the keyless chuck. FORWARD/REVERSE SWITCH 1.Pressing the forward switch in order to tighten the screws. 2.Pressing the reverse switch in order to loosen the screws. WARNING! Do not touch the bit during or immediately after operation.
Need help?
Do you have a question about the 8590 and is the answer not in the manual?
Questions and answers