Project EV EVA-07S-S User Manual page 12

Installation
Wall Mounted
3.1.3 Put the charge point onto the bracket, and x it with the 2 screws at the bottom of
3. Mount the charge point onto the bracket, and fix it with the 2 screws at the bottom of a
the charge point. The installation is done.
charge point. This will secure the charger to the bracket.
3.1.4 Crimp the insulated ferrule or ring terminals on the end of the AC input wires.
4. Remove the side plate, crimp the cables using insulated ferrule's into terminals
Connect the wires into the terminal block of the charge point as below. Check the
provided. Polarity can be found written on the PCB below the connections. Check the
wiring and then close the RCD in the side window. Close the side window with the
wiring before powering up - the RCBO is in the top window and may need the reset
indicator resetting by pressing this in before the RCBO can be reset. Once complete, re-fit cover, then the wiring is completed.
the access panel.
11
8
3.1.3 Put the charge point onto the bracket, and x it with the 2 screws at the botto
the charge point. The installation is done.
3.1.3 Put the charge point onto the bracket, and x it with the 2 screws at the
the charge point. The installation is done.
3.1.3 Put the charge point onto the bracket, and x it with the 2 screws at the b
the charge point. The installation is done.
3.1.3 Put the charge point onto the bracket, and x it with the 2 screws at the bottom of
the charge point. The installation is done.
3.1.4 Crimp the insulated ferrule or ring terminals on the end of the AC input wires.
3.1.4 Crimp the insulated ferrule or ring terminals on the end of the AC input w
Connect the wires into the terminal block of the charge point as below. Check the
3.1.4 Crimp the insulated ferrule or ring terminals on the end of the AC input w
Connect the wires into the terminal block of the charge point as below. Chec
wiring and then close the RCD in the side window. Close the side window with the
Connect the wires into the terminal block of the charge point as below. Check
wiring and then close the RCD in the side window. Close the side window wit
cover, then the wiring is completed. wiring and then close the RCD in the side window. Close the side window wit
cover, then the wiring is completed.
cover, then the wiring is completed.
3.1.4 Crimp the insulated ferrule or ring terminals on the end of the AC input wires.
Connect the wires into the terminal block of the charge point as below. Check the
wiring and then close the RCD in the side window. Close the side window with the
cover, then the wiring is completed.
8
8
8