Gree sapphire SAP09HP230V1AH Owner's Manual page 15

OPERATION OF WIRELESS REMOTE CONTROLLER (Continued)
46°F VACATION MODE (FREEZE GUARD)
• In Heat mode, press"TEMP"and "CLOCK" buttons
simultaneously to start up the "46°F VACATION
MODE" function. When this function is active, "46°F"
will be displayed on the remote controller, and the
unit will maintain room temperature above 46°F.
Press"TEMP" and "CLOCK" buttons simultaneously
again to cancel Freeze Guard protection.
I-FEEL MODE
• Press this button to use the I-FEEL function, and
the ( ) icon will be displayed. The unit will sense
room temperature at the remote controller instead
of at the indoor unit. It then adjusts airflow and
temperature accordingly for the ultimate in personal
comfort control and energy savings. Press the button
again to exit this function. For the best performance,
keep the remote controller within an area where
indoor unit can receive the signal sent by the remote
controller and away from heat or cold temperature
sources while using this function.
CLOCK
• Press this button to set clock time. "
remote controller will blink. Within 5 seconds, press
"+" or "–" button to set clock time. With each pressing
of "+" or "–" buttons, clock time will increase or
decrease 1 minute. To quickly adjust time setting,
press and hold "+" or "–" button for 2 seconds.
Release button when you have reached the desired
time setting. Press "CLOCK" button to confirm the
time, and " " icon will stop blinking.
NOTE:
• Clock time adopts 24-hour mode. A 12-hour format
is not available.
FAN
• Press the FAN button to adjust the fan circulation
indoor speed: Low ( ), Low-Medium ( ), Medium (
Medium-High (
Remote controller operations
To change batteries, slide cover off battery compartment
on back of remote controller. Remove and safely discard
old batteries. Insert two new AAA 1.5V dry batteries,
using correct polarity.
Reattach back cover.
NOTE:
• If the remote controller will not be used for a long
time, remove batteries to prevent leakage damage.
• Be sure to aim the remote controller at the receiver
" icon on
of the main unit when operating.
• When remote emits a signal, icon will flicker; a tone
will be heard when unit receives that signal.
V IR EO GE N 3 OW N ERS M A N UA L - I N D OOR U N I T
), High ( ) and Auto.
),
| 1 5