Gree sapphire SAP09HP230V1AH Owner's Manual page 13

OPERATION OF WIRELESS REMOTE CONTROLLER (Continued)
TRADITIONAL MODE - SLEEP 1
In Traditional Mode the unit will slowly relax the room
set temperature by up to 4° F until Sleep Mode is
cancelled.
EXPERT MODE - SLEEP 2
In Expert Mode the unit will adjust the room set
temperature at a rate based on the starting set
temperature value. Sleep Mode will continue until
cancelled.
DIY MODE - SLEEP 3
You will be required to enter eight (8) room setpoint
values for eight (8) hours of run time. The last room
setpoint value will be maintained until sleep mode is
cancelled.
• In Sleep Mode 3, press "Turbo" button to enter setup
mode. The remote controller will display "1 hour"
in the time location. Use the "+" and "–" buttons to
select the desired room setpoint for the first hour of
run time. Then press the "Prog" button to save the
setpoint.
• The remote controller time display will change to "2
hours." Once again, use the "+" and "–" buttons to
select the desired room setpoint for the second hour
of run time, and press the "Turbo" button to again
save the setpoint.
• Repeat this sequence for the eight (8) room setpoint
values. After all eight (8) values have been entered,
the remote controller will automatically revert to
standard time and temperature display, and the Sleep
3 Mode will begin.
• At any time, you may press the "ON/OFF," "Mode" or
"Sleep" buttons to cancel the Sleep 3 Mode.
NOTE:
• During this procedure, if no button is pressed within
10 seconds, remote controller will automatically exit
the sleep curve setting and resume original display.
If ON/OFF, MODE SLEEP, COOLING or HEATING
button is pressed during the setting or inquiry
procedure, remote controller will also exit the sleep
curve setting.
LIGHT
• Press this button to turn off display light on indoor
unit. Press again to turn it back on.
V IR EO GE N 3 OW N ERS M A N UA L - I N D OOR U N I T | 1 3