Replacing And Cleaning The Spark Plug - Energizer EZG Series Original Instructions Manual

5.5 - Replacing and Cleaning the Spark Plug

Do not rinse spark plug in water. Follow guidelines and be careful not to
overtighten the spark plug.
Tighten ½ turn when installing a new spark plug.
Tighten ¼ turn when re-installing an old spark plug.
1. Unscrew and remove spark plug access panel and screws.
2. Remove ignition coil from spark plug and remove spark plug with spark
plug wrench.
3. Inspect the spark plug and clean any dirt from the electrodes with a wire
brush. If electrodes are worn or show signs of wear, replace spark plug.
4. Measure the electrode gap with a spark plug gauge and adjust as
necessary by bending the side electrodes. Ensure that the gap is between
0.7 and 0.9mm
5. Reinsert the plug carefully. Tighten with a spark plug wrench.
Ignition Coil
28
Spark Plug