General Inspection Tips; Cleaning The Air Filter - Energizer EZG Series Original Instructions Manual

5.2 General Inspection Tips

1. Look for fuel leaks around the fuel tank, fuel hose, and fuel valve. Close the
fuel valve and repair leaks immediately.
2. Look and listen for exhaust leaks while the engine is running. Have all the
leaks repaired before continuing operation.
3. Check for dirt and debris and clean as necessary .
4. Check the engine oil level and add oil as necessary.
Do not use gasoline or low flash point solvents for cleaning. They are
flammable and could explode under certain conditions.
5.3 Cleaning The Air-Filter
Using gasoline or other flammable solvents can cause a fire or explosion.
Do not operate this product without an air filter.
1. Unscrew and remove the engine access panel.
2. Unscrew and remove the air filter assembly.
3. Remove the foam filter.
4. If the foam element is dirty, clean it in warm soapy water, rinse, and allow it
to dry thoroughly, or clean in non-flammable solvent and allow to dry.
5. Dip the foam element in clean engine oil, then squeeze out all excess oil.
The engine will smoke when started if too much oil is left in the filter.
6. Wipe dirt from the air filter unit and cover using a moist rag.
26